Drywall Repair Nail Pops and delete
First, the best way to determine the nail existing POP is to ensure that the head of the nail or screw is recessed about 1 / 32 inch. If it stops, do not drive too deep or it will break through the surface of the paper. If you do this, you will be in plaster deteriorate.
Next spread a little spackling compound over the area pop nail. Let it dry and then sand it down. There was a ruler on it to ensure that it is not too high. A place a bit 'raised is better than thattoo small. Let dry thoroughly, because the compound is reduced slightly.
Paint repaired area with a primer chalk. Paint an area that is larger than the standard position, so that the larger area of the top layer can absorb evenly. This makes it almost impossible to detect that the repair was made to the wall.
The problem with the pop style can be caused by improper installation of the gypsum by the manufacturer or damp wood. While kiln-dried lumber, presumably, couldpick up moisture over time, especially if it is already included in the rain for a while '.
That smashed plaster wall studs, or screw, shrink as they dry. Unfortunately, they are afraid the higher amount (due to the orientation of the grains) in all its dimension of depth (nominal 4 inches).
If the plaster is nailed to the wall studs and the studs wet fall just a little 'dry as a small difference between plaster and parade. It does not take much. If the plaster and Bumpedpushed back against the pin, the chapel causes a pop.
The best way to reduce POP nails are not used properly dried lumber. Since the project is a room next to the preservation of wood in your garage, the rain until it is spent. If possible, delay construction until the weather is very hot, but not during the months of high humidity.
Check every piece of wood used, since the adjustment of the structure is very important to ensure that the plaster to make goodcontact with them. Your manufacturer may be bent into any studs other areas, so it is not wasted.
Ensure that the proper cast nails and screws are used, and are the right length. This is different from the regular buttons. Drywall fasteners are specially shaped head, so I'm not tear the paper when it is cashed. Plaster 1/2-inch, 1 1/4-inch angle shanked nail plaster ring works well.
If possible, have your builder for a while 'waiting to be installed after gypsumwall design is complete and the room was closed kg The longer wait, the better. This allows time for the effect of drying wood and water content of all the pieces to stabilize.
The distance between the screws and bolts are equally important in reducing future nail pops and other problems. The maximum range of accessories for applying the plaster ceiling is 12 inches at the poles. This means that a four – footrest range of at least five buttons properly. Wallpanels, buttons 16 inches on centers.
